Rear Brake Caliper; Disassembly/Reassembly - Acura Integra 1998 Service Manual

Rear Brake Caliper
Disassembly/Reassembly
o Never use an air hose or dry brush to clean brake assemblies.
o Use an OSHA-approv€d vacuum cleaner to avoid breathing brake dust.
. Conlaminated brake discs or pads reduce stopping ability.
. When reusing the pads, always reinstall the brake pads in their original positions to prevent loss of braking efficiency,
CAUTION: Do not spill brake fluid on the vehicle; it may damags the paint; it brake fluid does contast the paint, wash it
off immediately with water,
NOTE:
. Coat the piston. piston seal, and caliper bore with clean brake fluid.
. Beplace all rubber parts with new ones whenever disassembled.
o Clean all parts in brake fluid and air dry; blow out all passages with compressed air.
a Before reassembling, check that all parts are free of dust and other foreign particles.
.
Replace parts with new ones whenever specified to do so.
.
Make sure no dirt or other foreign matter is allowed to contaminate the brake fluid.
. Always use Genuine Honda DOT3 Brake Fluid. Using a non-Honda brake fluid can cause corrosion and decrease the life
of the svstem.
Type R Model:
10 mm FLANGE BOLT
34 N.m 13.5 kg{.m,25 tbtftl
All 6xc€pt Typ6 R Modet:
8 mm FLANGE BOLT
23 N.m {2.3 kgf.m, 17 tbf.ft)
BANJO BOLT
3,0 N.m (3.5 kgt m, 2s tbtftl
Replace.
;,'"]@: Use recommended rubber grease in the caliper seal set.
.61, Use recommended seal grease in the catiper seal set.
PARKING NUT
RETURN SPRING
27 N.m 12.8 kgt m, \
\
2rtbt.frl
\ \
ar"t"o *or"a"=-\9
_r.r,e=
LEVER -------rCF
c^M Boor ---f
Re'lace
-==': /t8
"':sst
/-
CALIPER BOLTS
23 N.m
12.3 kgf.m, 17 lbf.ft)
TNNERPADSHTM
cAM
lAll except Typs R
CALIPER EODY
Model)
OUTER PAO SHIM
\ -db \
PAD SPRTNG
\ra71 ^ V
BRAKEPA''
vUffifi*
,*,
^ r r o r r / Y '
, / ^ ,
O.RING
B e p l a c e .
PINS
BLEED SCREW
9 N.m (0.9 kg{.m, 6.5 tbf.ft)
SEALING WASHERS
Replace.
PIN BOOT