Acura Integra 1998 Service Manual page 839

Doors
Outer Handle Replacement (cont'd)
irl
lii
,l
r
Latch Replacement
N O T E : R a i s e t h e g l a s s f u l l y .
1 . R e m o v e :
a Door panel (see page 20 20)
a Plastic cover (see page 20 20)
a O u t e r h a n d l e ( s e e p a g e 2 0 ' 2 3 )
2- Remove the screws and disconnect the connector,
t h e n r e m o v e t h e i n n e r h a n d l e a n d l a t c h .
NOTEr Take care not to bend the rods.
> | Screw locations, 2
6bD l
: )
CYLINDER ROO
>: Clip locaiions, 2
3 .
Installation is the reverse of the removal procedure.
NOTE: Make sure the inner handle rod, lock rod and
connector are connected properly.
6 .
7 .
v :
Disconnect the cylinder rod as shown.
NOTE: Take care not to damage the lock cylinder
J o r n t .
OUTER
HANDLE
SHOP TOWEL
Remove the cylindef switch from the outer handle.
Pull out the retainer clip, then remove the lock
cylinder and cylinder protector.
8 .
L
g--.-.o"*
cYLTNDER
lnstallation is the reverse of the removal procedure.
N O T E :
a Make sure the outer handle rod and connector are
connected securely.
a Make sure the wire harness is routed properly.
a Make sure the door locks and opens properly.
LOCK CYLINOEB