Hatch Opener
Hatch Opener Switch Test/
Replacement
Remove the hatch trim panel (see section 20).
Disconnect the 2P connector from the switch.
3.
Check for continuity between the terminals in each
swatch position according to the table.
4.
lf necessary, remove the two mounting bolts to pull
out the hatch opener switch from the hatch.
1 .
2 .
1 .
2 .
Hatch Opener Actuator Test
Remove the rear trim panel (see section 20).
Disconnect the 2P connector from the actuator.
3.
Check actuator operation by connecting power and
ground according to the table.
CAUTION: To prevent damage to the actuator,
apply battery voltage only momentarily.
Terminal
Position
B
O N
o
O F F
Terminal
Position
B
O P E N
@
o
23-252
4.
lf the actuator fails to work properly, replace it.
{