Driveshafts
Reassembly (cont'dl
-6. Raise up the boot band tool to bend the free
end of the band 90 degrees to the clip. Center
punch the clip, then fold over the remaining tail
onto the clio.
- 7. Unwind the boot banding tool, and cut off the
excess free end of the band to leave a 5 - '10
mm (0.2 - 0.4 in) tail protruding from the elip.
HAMMER
5 - 1 0 m m
(0.2 - 0.a inl
16 -1 2
- 8. Bend the band end by tapping it down with a
n a m m e r .
NOTE:
. Make sure the band does not move.
. Remove any grease remaining in the surround-
ing surfaces.