Table of Contents
Advertisement
lgnition System
Coil Test
lgnition
lgnitionCoil Replacement
1. With the ignition switch OFF, remove the distribu-
tor ignition (Dl) cap, rotor, and cap seal, then remove
the leak cover.
Remove the two screws to disconnect the BLK/YEL
and WHT/BLU wires lrom the coil.
Remove the two screws, and slide the ignition coil
out of the distributor ignition (Dl) housing.
DISTRIBUTOR IGNITION {DII
HOUSING
ROTOR
WHT/BLU WIRE
2 .
1 .
With the ignition switch OFF, remove the distribu-
tor ignition (Dl) cap.
Remove the two screws to disconnect the BLK/YEL
and WHT/BLU wi.es from terminals A ( + ) and B {- )
respectively.
SECONDARY
WINDING
TERMINAL
3. Using an ohmmeter, measure resistance between
the terminals. ReDlace the coilif the resistance is not
within soecifications.
NOTE: Resistance will vary with the coil temper-
ature; specifications are at 68oF (20oC)
Plimary Winding Rssistance
(Between th€ A 8nd B torminalsl: 0.6-O,8 ohms
Socondary Winding Resistance
(Betwe€n the A and secondary winding torminalsl:
12.4-19.2 kA
B ( - t
SECONDARY
WllrlDlNG
TENMINAL
T E R M I N A L A ( + I
A { + }
{
t
l
tl
t
9
t
L--
23-96
Advertisement
Table of Contents
Troubleshooting
