Table of Contents
Advertisement
Key-in Reminder S ystem
lgnition Key Switch
Test
\f
Door
Switch
Test
1 . O p e n t h e d o o r .
2.
Remove the screw, then pull out the door switch.
3.
Disconnect the 1P connector from the switch.
1P CONNECTOR
4.
Check for continuity between the positive terminal
and the base plate (ground) in each switch position
accordinq to the table.
BASE PLATE
\
Terrninal
Position
POSITIVE
BASE PLATE
PUSHED
(door closedl
RELEASED
(door open)
o
o
NOTE: Refer to page 23-153 for a diagram of the key-
in reminder circuit, and to page 23-148 for the input test
of the beeper circuit.
When the ignition key is not removed. the key-in reminder
in the integrated control unit senses ground through the
closed ignition key switch. When you open the driver's
door, the beeper circuit senses ground through the closed
door switch. With ground at the "LT BLU" and "GRN/
BLU" terminals, the beeper sounds.
1. Remove the d;shboard lower cover and knee bolster
(see page 23-71).
2 . D i s c o n n e c t t h e 7 P c o n n e c t o r f r o m t h e m a i n w i r e
narness.
3. Check lor continuity between the No. 2 and No. 4
terminals in each condition according to the table.
\
Terminal
Condition
2
KEY INSERTED
o--
o
KEY BEMOVED
23-1 5 8
Advertisement
Table of Contents
Troubleshooting
