Table of Contents
Advertisement
Fuel Gauge
Sending Unit Test/Replacement
@oo
not smoke while working on tha fu6l
system. Keep open llames away trom youl work alea.
1. Remove the rear seat {see section 2O}.
2. Remove the protective cover and access panel trom
the floor.
3. With the ignition switch OFF, disconnect the 3P con-
nector from the fuel gauge sending unit.
4.
Remove the fuel gauge sending unit.
o
23-132
Float Position
E
1 t 2
F
Resistance (Ol
1 0 5 - 1 1 0 2 5 . 5 3 9 . 5
2 5
5. lreasure the resistance between the A and B termi-
n a l s a t E ( e m p t y ) , l / 2 ( h a l f f u l l ) a n d F { f u l l } b y m o v -
ing the tloat.
6. Check the change in resistance by moving the float
u o a n d d o w n .
(
1 . lf unable to obtain the above readings or if resistance
does not change, replace the fuel gauge sending unit.
NOTE: Use new O-rings or packings when reassem-
bling. For details, refer to section 1 1.
Advertisement
Table of Contents
Troubleshooting
