Table of Contents
Advertisement
Disassembly
13. Pull the knuckle outward. then remove the drive-
shaft outboard joint from the front wheel hub using
a plastic hammer.
KNUCKLE
DRIVESHAFT
l .
Careful clamp the driveshaft in a vise with soft jaws,
then remove the set ring from the inboard joint.
R e m o v e t h e b o o t b a n d s o n t h e i n b o a r d i o i n t a n d
outboard joint.
CAUTION: Take care not to damags th€ boot.
-
lf the boot band is a welded type or a low profile
type boot band, carefully cut it off with a pair of
diagonal cutters.
2 .
-
lf the boot band is a double loop band type, raise
the band bend as shown.
OOUBI-E LOOP BAND
Replace.
(cont'd)
1 6 - 5
Advertisement
Table of Contents
Troubleshooting
