Table of Contents
Advertisement
HEATER FAN SWITCH
Test, page 21 30
AIR MIX CONTROL CABLE
Adjustment, page 21-27
Air Mix Contlol Cable ReDlacement
1 . C u t t h e i n n e r c a b l e o n t h e l e v e r s i d e o f t h e c a b l e
holder, then remove both pieces of the inner cable.
2 .
Using a shafp knife, cut completely through the end
of the cable housing at the two locations.
Slide the large section of the cable housing out of
the cable holder, being careful not to damage the
cable stops.
Carefully remove the cut pieces of the cable hous
ing with a small tlat tip screwdriver.
Hook the tip of the new air mix cable to the temper-
ature control lever, then push the cable housing into
the cable holder until it locks place.
3 .
AIR MIX
CONTROL
CABLE
5 .
NOTEr Atter assembly, check that the temperature control lever slides smoothly through the full stroke from right
to left.
Heater Control Panel
Overhaul
t
21-26
Advertisement
Table of Contents
Troubleshooting
