Acura Integra 1998 Service Manual page 1266

Switch
Test
SRS comDonents are located in this area. Review the
SRS component locations, precautions, and procedures
in the SRS section (23) before performing repairs or ser-
vtce.
NOTE: The original radio has a coded thett protection cir-
cuit. Be sure to get the customer's code number beJore
- disconnecting the battery.
-
removing the No. 47 (7.5 A) fuse from the under-hood
fuse/relay box.
-
removing the radio.
After service, reconnect Dower to the radio and turn it on.
When the word "CODE" is displayed, enter the customer's
5-digit code to restore radio operation
Disconnect the battery negative cable, then discon-
nect the positive cable, and wait at least three min-
uIes.
Disconnect each airbag connector.
Driver's Side:
a Remove the access panel from the steering wheel,
then disconnect the 2P connector between the
driver's airbag and cable reel.
Front Passenger's Side:
. Remove the glove box,
a Disconnect the 2P connector between the front
passenger's airbag and SRS main harness.
1 .
Remove the dashboard lower cover and knee bolster
(see page 23-71).
Disconnect the cable reel 3P conneclor from the main
wtre narness.
CABLE REEL SUB.HARNESS
3P CONNECTOR
Check for continuitv between the No. 2 terminal of the
cable reel sub-harness and body ground with the
horn switch Dressed.
t e r m i n a l s i d e
a
It there is continuity, the horn switch is OK.
lf there is no continuity, go to step 6.
(cont,d)
r-P r
1 1 2 3 l
-t-
I
I
\-J
)
I
23-209