Acura Integra 1998 Service Manual page 640

1 . Wrap the splines with vinyl tape to prevent damage
to the boots and dvnamic damoer.
VINYL TAPE
OYNAMIC DAMPER
INBOARD BOOT
2 . I n s t a l l t h e o u t b o a r d b o o t , d y n a m i c d a m p e r a n d
i n b o a r d b o o t t o t h e d r i v e s h a f t , t h e n r e m o v e t h e
v i n y l t a p e .
CAUTION: Take care not to damage the boots and
dynamic damper.
3.
Pack the outboard joint with the joint grease includ-
ed in the new driveshaft set.
Grease quantily:
USA model: 90 - 100 g (3.2 - 3.5 oz)
Canada model: 105 - 115 g (3.7 - 41 oz)
I
5 .
Install the spider on the driveshaft by aligning the
marks on the spider and end of the driveshaft.
Fit the circlip into the driveshaft groove.
NOTE: Always rotate the circlip in its groove to be
sure it is fully seated.
@*c'nc'-'t
SPIDEB
6. Fit the rollers to the spider with their high shoulders
facing outward.
Note these items during reassembly:
. Reinstall the rollers in their original positions on
the spider by aligning the marks.
. H o l d t h e d r i v e s h a f t p o i n t e d u p t o p r e v e n t t h e
rollers from falling off.
H i g h s h o u l d e r { a c e s
Marks
(cont'd)
SPIOER
1 6 - 9