Table of Contents
Advertisement
Troubleshooting
The SRS Indicator Light Doesnt Come On (cont'd)
From page 23-293
( B )
Ch.cl th. SRS indicator light circuit:
1. Disconnect the dashboard wire harness 5P connector from
the gauge assembly.
2. Connect a voltmeter belween the No. 5 terminal (+) of
the 5P connoctor and ground.
3. Turn the ignition switch ON {ll}, and measure voltage.
ls the.e 8.5 V or less for six 3econd! rflor lho ignition
switch h.s be6n turned ON llll?
YES
NO
Faulty SRS indicstor light circuit in ihe gtugo
assembly; r€pl.co tho SRS printed circuit board in
the gaug. assembly.
Check the wiro ham.ss of tho SRS indicltor light circuh ll l:
1. Turn the ignition switch OFF.
2. Disconnect the main wire harn€ss 16P connector lrom
the dashboard wire harness.
3. Connect a voltmeter betlveen the No. 15 torminal {+) of
the main wire harness 16P connector and ground.
4. Turn the ignition ON (ll), and measure voltage.
13 there 8,5 V or lc.r tor 3lx s.condr lftor th. ignition
switch h.3 boon tuJnod ON llll?
Short to powor In th. BLU wiro ot ths d$hbolrd wha
hrmess; ropair the hsmo*1.
To pag€ 23-295
DASHBOARD WINE HAR ESS
16P CONNECTOR
MAIN WIRE HARI{ESS
16P CONNECTOR
From page 23-293
DASHBOAND VUIRC HARNESS
5P CONNECTOB
DASHBOARD WIRE HARI{ESS
5P CONNECTOR
23-294
Advertisement
Table of Contents
Troubleshooting
