Table of Contents
Advertisement
CAUTION: Do not reuse the thruEt shim and th€ 79.5
mm shim if the outer race was driven out.
N O T E :
a The bearing outer race and tapered roller bearing
should be reDlaced as a set.
a Inspect and adjust the tapered roller bearing preload
whenever the tapered roller bearing is replaced.
1 . Remove the oil seals from the transmission housing
a n d c l u t c h h o u s i n g ( s e e p a g e 1 5 - 1 3 ) .
2.
Remove the bearing outer race, the thrust shim, and
the 79.5 mm shim from the transmission housino.
DRIVER
07749-0010000
SEAL ORIVER
ATTACHMENT
07JAD -PH80101
DRIVER, 40 mm LD.
07746 -O030100
3 .
TRANSMISSION HOUSING
Remove the bearing outer race and thrust shim from
the clutch housing.
CLUTCH
HOUSING
ORIVER
ATTACHMENT
07NAD-PX40100
ATTACHMENT
o7f{AD-PX40lOO
DRIVER
o7749 -0010000
TRANSMISSION
HOUSING
BEARING
OUTER
RACE
7 9 . 5 m m
SHIM
BEARING
OUTER
RACE
THRUST SHIM
T. 2.5 mm 10.098 inl
lnstall the new thrust shim and 79.5 mm shim. then
drive the bearing outer races in the both housings
using the special tools as shown.
NOTE:
a Install the bearing outer race squarely.
a Check that there is no clearance between the
bearing outer race. thrust shim, and transmission
housing.
ORIVEB
5 . I n s t a l l t h e o i l s e a l ( s e e p a g e 1 5 - 1 7 ) .
Differential (818C1 engine)
Bearing Outer Race Replacement
15-14
\ l
\
\
Advertisement
Table of Contents
Troubleshooting
