r
Doors
Glass Adjustment
< : Screw locations, 5
"od} l
- , /
N O T E :
a Place the vehicle on a firm, level surface when adjust-
i n g t h e g l a s s .
a Check the weatherstrips and glass run channel for
damage or deterioration, and replace them iI
necessarY.
1 .
Remove the door panel, and peel off the plastic cover
(see page 20 4).
2.
Remove the power window switch from the door
p a n e l .
DOOR PANEL
3 .
Connect the power window switch to the door
h a r n e s s .
Make sure the guide pin is installed in the center
c h a n n e l g u i d e p r o p e r l y .
CENTER CHANNEL
GUIDE
GUIDE PIN
20-16
5. Raise the glass as iar up as possible, and hold it
a g a i n s t t h e g l a s s r u n c h a n n e l .
6.
Loosen the roller guide bolts, and adjust the glass
s o i t i s p a r a l l e l w i t h t h e g l a s s r u n c h a n n e l .
GUID€
PIN
CENTEB
CHANNEL
G U I D E
ROLLER GUIDE BOLTS
7. Tighten the roller guide bolts.
8.
Check that the glass moves smoothly.
9.
It necessary, adjust the lront and center channels.
CHANNEL
GLASS RUN CHANNEL
D\