Table of Contents
Advertisement
20.
21.
Remove the cotter pin from the lower arm ball joint
castle nut. and remove the nut.
Install a 12 mm hex nut on the ball joint. Be sure
that the hex nut is flush with th€ ball joint pin end,
or the threaded section of the ball joint pin might be
damaged by the ball joint remover.
Use the special tool as shown on page 18-12 to sep-
arate the ball joint and lower arm.
NOTE: lf necessary. apply penetrating type lubri-
cant to loosen the ball joint.
12 x 1.25 mm
)
23.
24.
Remove the cotter pin from the upper ball joint cas-
tle nut, and remove the nut,
Installthe 12 mm hex nut on the ball joint.
Be sure that the hex nut is flush with the ball joint
pin end, or the threaded section of the ball joint pin
might be damaged by the ball joint remover.
Use the special lool as shown on page 18-12 to sep-
arate the ball joint and knuckle.
NOTE: lf necessary, apply penetrating type lubri-
cant to loosen the ball joint.
CASTLE NUT
Pull the knuckle outward and remove the driveshaft
outboard joint from the knuckle using a plastic ham-
mer, then remove the knuckle.
(cont'd)
25.
COTTER
Replace.
26.
OUTBOARD JOINT
1 8 - 1 3
Advertisement
Table of Contents
Troubleshooting
