Acura Integra 1998 Service Manual page 386

Shift Fork Assembly
Clearance Inspection
NOTE: The synchro sleeve and the synchro hub should
h 6 r o n l r . o . l , . . c a r
Measure the clearance between each shift fork and
its matching synchro sleeve.
Standard:
0.35 - 0.65 mm {0.014 - 0.026 inl
Service Limit: 1-0 mm 10.04 inl
SHIFT FORK
lf the clearance is more than the service limit, mea-
sure the thickness of the sh ift fork finoers.
Standard: 7.il - 7.6 mm (0.291 - 0.299 in)
l f t h e t h i c k n e s s o f t h e s h i f t f o r k f i n g e r s i s n o t
within the standard, replace the shift fork with a
lf the thickness of the shift fork fingers is within
the standard, replace the synchro sleeve with a
new one.
3.
Measure the clearance between the shift piece and
the shift fork shafts.
Standard:
0.2 - 0.5 mm (0.008 - 0.02 inl
Service Limit: 0.8 mm (0.03 inl
SHIFT PIECE
It the clearance is more than the service limit,
sure the width of the shift piece.
Standard: 11.9 - 12.0 mm (0.a69 - 0.a72 inl
lf the width of the shift piece is not within the
standard, replace lhe shift piece with a new one.
lf the width of the shift piece is within the stan-
dard. reolace the shift fork with a new one.
IFT FORK
/
SHIFT PIECE