Acura Integra 1998 Service Manual page 1055

Condenser
J
Replacement
RADIATOR UPPER
MOUNT BRACKETS
Recover the refrigerant with a Recovery/Recycling/
Charging System lsee page 22-221.
Remove the coolant reservoir.
NOTE: Do not disconnect the reservoir hose from
the coolant reservoir and the radiator.
R e m o v e t h e b o l t s a n d t h e r a d i a t o r u p p e r m o u n t
b r a c k e t s . t h e n r e m o v 6 t h e b o l l f r o m t h e s u c t i o n
hose bracket.
COOLANT RESERVOIR
6 x 1 . 0 m m
9.8 N'm 11.0 kgf'm, ?.2lbf'ft)
4 . R e m o v e t h e b o l t s , t h e n d i s c o n n e c t t h e d i s c h a r g e
line and the condenser line from the condenser.
NOTE: Plug or cap the lines immediately after dis-
connecting them to avoid moisture and dust con'
tamination.
DISCHARGE LINE
6 x 1 . 0 m m
9.8 N.m {1.0 kgj'm, 7.2 lbl'ft)
5.
Remove the two mounting bolts, then lift out the
condenser as shown.
NOTE: Be careful not to damage the radiator and
condenser fins when removing the condenser.
6 x 1 . 0 m m
9.8 N m 11.0 kgf m, 7.2 lbf ft)
lnstall in the reverse order of removal. Make note of
these items;
. lf you're instslling a new condenser, add refriger-
ant oil (ND-olL 8: P/N 38897-PR7-A01AH
or 38899
- PR7 - A01) (see page 22-211.
. Replace the O-rings with new ones at each fit-
t i n g , a n d a p p l y a t h i n c o a t o f r e f r i g e r a n t o i l
before installing them.
NOTE: Be sure to use the right O-rings for HFC-
134a (R-1344) to avoid leakage.
a Do not damage the radiator and condenser fins
when installing the condenser.
o Be sure to install the condenser mount cushions
securely into the holes.
. Charge the system {see page 22-39) and test its
performance (see page 22-241.
CONOENSER LINE
22-37