Table of Contents
Advertisement
Driveshafts
Reassembly (cont'd)
7.
Pack the inboard joint with the joint grease included
in the new driveshaft set.
Grease quantity: 120 - f30 g 11.2-4.6ozl
Fit the inboard joint onto the driveshaft.
NOTE:
.
Reinstall the inboard joint onto the driveshaft by
aligning the marks on the inboard joint and the
ro ers.
. Hold the driveshaft so the inboard joint points up
to p.event it from falling off.
DRIVESHAFT
1 6 - 1 0
8 .
9 . F i t t h e j o i n t b o o t e n d s o n t o t h e d r i v e s h a f t a n d
Jornts.
W h e n i n s t a l l i n g t h e o u t b o a r d j o i n t b o o t o n a
Canada model, be sure the end of the boot is seated
in the grooves of the driveshaft and outboard ioint.
Adjust the length of the driveshafts to the specifica-
t i o n s b e l o w , t h e n a d j u s t t h e b o o t s t o h a l f w a y
between full compression and full extension.
NOTE: The ends of boots seat in the groove of the
driveshaft and joint.
Lefr: 475 - 480 mm {18.7 - 18.9 inl
Right:475 - 480 rnm (18.7 - 18.9 int
1 0 .
OUTBOARD BOOT {TPE)
C a n a d a A T m o d e l
o u t b o a r d j o i n t o n l y .
Advertisement
Table of Contents
Troubleshooting
