Acura Integra 1998 Service Manual page 1295

Power Windows
Driver's Window Motor Test
Motor Test:
'1.
Remove the driver's door panel (see section 20).
2. Disconnect the 4P connector from the motor.
View from terminal side
4P CONNECTOR
3. Test the motor in each direction by connecting bat-
tery power and g.ound according to the table.
CAUTION: When the motor stops running, discon-
nect one lead immediately.
4. lf the motor does not run or fails to run smoothly.
reprace rI.
Pulser Test:
5. Connect the test leads of an analog ohmmeter to the
: and D terminals.
6. Run the -noror by connecting power and ground to
t h o A a n O 8 : e r r n i n a l s .
Thg ohmrneter need e should move back and forth
alternately,
1 .
2 .
Passenger's Window Motor Test
Remove the passenger's door panel {see section 20).
Disconnect the 2P connector from the motor.
N O T E :
a Front passenger's door is symmetricalto driver's
door.
a The illustration shows the right rear door. left rear
door is symmetrical.
2P CONNECTOR
View from terminal side
3. Test the motor in each direction by connecting bat-
tery power and ground according to the table.
CAUTION: When the motol stops running, discon-
nect one lead immediately.
lf the motor does not run or fails to run smoothlv,
reprace rI.
(
I
\
T e r m i n a l
Direction
{ B )
B
{At
UP
o
@
DOWN
@
o
\
Terminal
O'*"r*-T
B
UP
o
@
DOWN
@
o
23-240