Table of Contents
Advertisement
20. Apply vinyl tape to the pinion shaft.
Separate the valve housing from the pinion shaft/
valve ustng a press.
VALVE HOUSING
V i n y l l a p e
PINION SHAFT
Check the inner wall of the valve housing where the
seal ring slides with your finger. It there is a step in
t h e w a l l , t h e v a l v e h o u s i n g i s w o r n , B e p l a c e t h e
valve housing.
N O T E : T h e r e m a y b e t h e s l i d i n g m a r k s t r o m t h e
seal ring on the wall of the valve housing. Replace
the valve housing only if the wall is stepped.
2 1 .
22.
2 3 . C h e c k f o r w e a r , b u r r s a n d o t h e r d a m a g e t o t h e
edges of the grooves in the sleeve.
NOTE: The pinion shaft and sleeve are a precision
m a t c h e d s e t . l f e i t h e r t h e p i n i o n s h a l t o r s l e e v e
must be replaced, replace the both parts as a set.
SLEEVE SEAL RINGS
Check for peel off or
d a m a g e .
24. Remove the circlip and
pinion shaft,
pinion shaft sleeve from the
( c o n t ' d )
Advertisement
Table of Contents
Troubleshooting
