Acura Integra 1998 Service Manual page 1328

Rear Window Wiper Motor Test
J
J
1 . Disconnect the 4P connector from the wiper motor.
3.
lf the motor does not run or fails to run smoothly,
replace it.
4 . R e c o n n e c t t h e 4 P c o n n e c t o r t o t h e w i p e r m o t o r
assemDty.
5. Connect an analog voltmeter between the D (LT
GRN/BLK) and B (BLKI terminals. Run the motor by
turning the wiper switch ON.
The voltmeler should alternately indicate O V and
m o r e t h a n 4 V .
NOTE: Use an analog tester.
1P
CONNECTOR
A (GRN/BLKI
C IGRN)
View from terminal side
2. Test the motor by connecting battery power to the
A {GRN/BLK) and ground to the C (GRN) terminals.
The motor should run smoothly.
C IGRN}
) ;
23-273