Power Steering Hoses, Lines
Replacement
NOTE:
. Connect each hose to the corresponding line securely
until it contacts the stop on the line. Install the clamp
or adjustable clamp at the specified distance from the
hose end as shown.
. Add the recommended power steering fluid to the
specified level on the reservoir and check for leaks.
ADJUSTABLE HOSE CLAMP: (al
. P o s i t i o n t h e a d j u s t a b l e h o s e c l a m p s a t t h e p o i n t s
indicated by (a) in the drawing below.
. Slide the hose over the line until it contacts the stop.
CAUTION: Ch€ck all clamps for deterioration or defor-
mation; replace the clamps with new ones it necessary'
HOSE CLAMP: (b)
.
Position the hose clamps at the points indicated by
(b) in the drawing below.
. Slide the hose over the line until itcontactsthe stop.
2.5 - 5.5 mm
(0.01 - 0.22 in)
RETURN LINE JOINT
28 N m 12.9 kg{'m,2'l lbf'ft|
PUMP OUTLET HOSE
(High'pressure)
37 N.m (3.8 kgtm,27 lbf.ft)
2 . 5 - 5 . 5 m m
10.01 - 0.22 in)
2.0 - {.0 mm
10.08 - 0.16 inl
CYLINDER LINES
17 N.m (1.7 kgt m, 12 lbf'ft)
PUMP
OUTI.IT HOSE
(High-pressure)
11 N.m
11.1 kgl.m,8lbJftl
PUMP
INLET HOSE
(Low-pressurel
RETURN HOSE
Exc.pt Bl8Cl engino
17-34