1. Install the new pump seal in the pump housing by
hand, then install the pump seal spacer.
6.
Set the pump cam ring over the two rollers with the
" c " mark on the cam ring upward.
NOTE: Insen the pump seal with its grooved side
facing in,
Position the pump drive shaft in the pump housing,
then drive the it in using a 29 mm socket as shown.
Install the 40 mm circlip with its radiused side fac-
3 .
ang out.
29 mm S(rcKET
Z-\
g
u<-{} mm clRcLlP
BALL BEARING
PUMP DRIVE SHAFT
PUMP SEAL SPACER
a )
7 . Assemble pump rotor to the pump cover with the
"
" marks
on the rotor tacing down.
Set the 10 vanes in the grooves in the rotor.
NOTE: Be sure that the round ends of the vanes are
in contact with the sliding surface of the cam ring.
8.
4.
f l u i d . a n d i n s t a l l i t i n t o t h e g r o o v e i n t h e p u m p
cover.
5.
Install the outer side plate over the two rollers.
PUMP FOTOR
PUMP VANES
110 platesl
0
r
gn
OUTER SIDE PIATE
PUIIIP COVER SEAL
Replace.
a.5 mm ROLLfR
PUMP CAM RING
ROLI.-ER SET HOLES
ROLLEB SET HOITS
Bound ond
PUMP COVER
5 mm ROLLER
(cont'd)