Disassembly/Reassembly
1. Using a hydrsulic press, press out the countershaft
while supponing 4th gear.
NOTE: Place an attachment between the oress and
the countershaft to prevent damage to the shatt,
CAUTION: Do not allow th€ count€rshaft to fall rnd
hit the ground.
T
T
2. Assemble the parts on the countershaft as shown
below.
NOTE:
a Lubricate all parts with ATF during assembly.
a Before installing the O-rings, wrap the shaft
splines with tape to prevent damaging the
O-rings.
'{EEDLE EEARIIIG
DISTANCE COLLAR, 28 mm
Selectivo part.
THRUST NEEDLE BEARING
BEARING
GEAR COLLAR
TI{BUST NEEDLE BEARING
WASHER
CLUTCH ASSEMBLY
(cont'd)
14-137