Table of Contents
Advertisement
Sub-shaft Bearings
Replacement
NOTE: Lubricate all parts with ATF before reassembly.
1 . To remove the sub-shaft ball bearing from the trans-
mission housing, expand the snap ring with snap ring
pliers, then push the bearing out using the special
tools and a press as shown.
ATTACHMENT. 62 r 68 mm
07746-0010500
Remove the needle bearing stopper.
Remove the needle bearing from the transmission
housing using a drift punch.
DRIFT PUNCH
L
14-144
7A
SNAP RING
Install the new needle bearing in the transmission
housing using the specialtools and a press as shown.
PRESS
ATTACHMENT,
32 x 35 mm
07746-0010roo
Expand the snap ring with snap ring pliers, then in-
sert the ball bearing part-way into the housing us-
ing the special tools and a press as described in step
1. Installthe bearing with the groove facing outside
t h e h o u s i n g .
Release the pliers, then push the bearing down into
the housing until the snap ring snaps in place around
rt.
After installing the ball bearing, verity the following:
a The snap ring is sealed in the bearing and hous-
ing grooves.
a The snap ring operates Properly.
a The ring end gap is correct.
5 .
6 .
7 .
END GAP: 0-7 mm
Advertisement
Table of Contents
Troubleshooting
