Acura Integra 1998 Service Manual page 964

Integra 1998

Hide thumbs Also See for Integra 1998:

Table of Contents

Remove the upper anchor bolts from the front and

rear seat belts (see pages 20-111,1211, then remove

t h e u p p e r p o r t i o n o f t h e q u a r t e r p i l l a r t r i m p a n e l

(see page 20-99).

Remove the rear roof trim, then pull the rear of the

h e a d l i n e r d o w n ( s e e p a g e 2 O - 9 9 ) .

N O T E : T a k e c a r e n o t t o b e n d t h e h e a d l i n e r .

Remove the support strut on each side while hold-

i n g t h e h a t c h .

NOTE: Do not raise the hatch too far; the corners

of the glass may hit the roof and break.

Remove the nuts, then remove the hatch.

: Nut locations, 4

NOTE: lf necessary, replace the support strut.

lf necessary, remove the hatch hinge.

V : Boll locations, 4

I x 1 . 2 5 m m

Installation is the reverse of the removal procedure.

a lf necessary, replace any damaged clips.

a Make sure the connectors are connected properly.

a N4ake sure the hatch locks securely.

a Make sure the hatch opens properly.

. Adjust the hatch alignment (see page 20-150).

Troubleshooting