Acura Integra 1998 Service Manual page 1143

Starter Reassembly
Starting System
Solenoid Plunger Inspection
Check the contact points and the face of the starter sole
noid plunger for burning, pitting or any other defects. lf
surfaces are rough, recondition them with a strip of
# 500 or # 600 sandoaoer.
POINT CONTACTING
FACE
NOTE: Use the illustration on page 23-81 as a reference
for reassembly.
1. Pry back each brush spring with a screwdriver, then
position the brush about halfway out of its holder,
and release the spnng to hold it there.
2.
Install the armature in the housing. Next pry back
each brush spring again and push the brush down
until it seats against the commutator. then release
the spring against the end ol the brush.
\
SPRTNG
fi49-d
E I V
I R
, , \
li N,."
3. lnstall the end cover on the brush holder.
O-RING
23-86