Table of Contents
Advertisement
Installation
1. Install the outboard joint into the knuckle.
Apply 0.5 - 1.0 g {0.02 - 0.04 oz) of specified grease
to the whole splined surface of the left driveshaft.
NOTE: After applying grease, remove the grease
from the splined grooves at intervals of 2 - 3 splines
and from the set ring groove so air can bleed from
the inboard ioint.
SET RING
Replace.
SET RING
Install a new set ring onto the driveshaft or interme-
diate shaft groove.
KNUCKLE
OUTBOARD JOINT
16 -1 4
4.
lnsen the inboard end of the driveshaft into the dif-
f e r e n t i a l o r i n t e r m e d i a t e s h a f t u n t i l t h e s e t r i n o
locks in the groove.
INEOARD JOINT
INBOARD JOINT
Replace.
lnstall the damoer fork over the driveshaft and onto
t h e l o w e r a r m . I n s t a l l t h e d a m p e r i n t h e d a m p e r
fork so the aligning tab is aligned with the slot in
the damoer fork.
ALIGNING TAB
6.
Loosely install the flange bolts and the new self-
locking nut.
NOTE: The bolts and nut should be tightened with
the vehicle's weight on the damper.
GROOVE
OIFFERENTIAL
FLANGE BOLT
10 x 1.25 mm
43 N.m {4.4 kgf.m,32lbtftl
Advertisement
Table of Contents
Troubleshooting
