Bleeding - Acura Integra 1998 Service Manual

Bleeding
CAUTION:
. Oo not reuse the drsined fluid,
. Always use Genuine Honda DOT 3 Brake Fluid. Using
a non-Honda brake fluid can cause corrosion and
decrease the lile of the system,
a Make sure no dirt or other foreign matt€t is allowed
to contaminate the brske fluid.
. Do not spill brake fluid on tho car, it may damage the
pain; if brake fluid does contact the paint, wash it off
immediately with water.
NOTE: The reservoir on the master cylinder must be at
the MAX (upper) level mark at the start of bleeding pro-
cedure, and checked after bleeding each brake caliper.
Add fluid as required.
1. Make sure the brake fluid level in the reservoir is at
the MAX (upper) level line.
MAX (UPPER) I.IVEL
LINE
CYIINDER
Have someone slowly pump the brake pedal sever-
al times, then apply steady pressure.
Loosen the brake bleed screw to allow air to escape
from the system. Then tighten the bleed screw se-
c u r e l y .
Repeat the procedure for each wheel in the sequence
shown below, until atr bubbles no longer appear in
the fluid.
R e f i l l t h e m a s t e r c y l i n d e r r e s e r v o i r t o t h e M A X
(upperl level line,
BLEEDING SEOUENCE:
e, Front Right
O Roa. Right
O Front Left Gt Raar L€ft
Bleed the front calipers first.
NOTE:
19-7
F R O N T :
R E A R :
9 N . m { 0 . 9 k g I ' m , 6 . 5 l b t . f r )
/
l c
,, l,