Acura Integra 1998 Service Manual page 1202

Replacement
1. Remove the console. then disconnect the 14P con-
nector from the switch.
2.
Remove the two console switch mounting nuts.
3 .
1 .
Position the switch slider to "Neutral" as shown
above.
Move the shitt lever to "Neutral", then slip the
switch into position.
Attach the switch with the two nuts.
Test the switch in the @ and I
position of the shift
lever. The engine should start when the shift lever
is in position E anywhere in the range of free play.
Connect the l4P connector, clamp the harness and
install the console.
5 .
)
-
A/T Gear Position Switch A/T Gear Position Switch
Adjustment
1. Shitt to the @ position, and loosen the nuts.
2. Slide the switch in the direction of @
position
lwithin 2.0 mm (O.079 in.)l so that there is continuity
between the
"A" and "L" terminals in the range oI
free play oI the shift lever.
3.
Recheck for continuity between each of the ter-
m a n a l s .
N O T E :
a ll adjustment is not possible, check for damage
to the shift lever detent and/or the bracket. lf
there is no damage, replace the console switch.
a The engine should start when the shift lever is in
position S
in the range of free play.
E position
)
LOCK PIN
'/ia
NUTS
23-145