Table of Contents
Advertisement
Blower Unit
Replacement
NOTEr The blower motor, recirculation control motor
and blower resistor can be replaced without removjng
t h e b l o w e r u n i t ( s e e p a g e 2 1 - 2 1 ) .
Remove the glove box {see section 20}.
Remove the four bolts and the glove box frame.
Without Air Conditioning
3-a. Remove the wire harness clips trom the heater duct.
Remove the tour self-tapping screws and the heat-
er duct.
1 .
2 .
HEATER DUCT
21-20
With Air Conditioning
3-b. Remove the evaporator (see page 22-26).
CLIPS
9 . 8 N . m 1 1 . 0 k g f . m ,
7.2 rbf.ftl
4.
Disconnect the connectors from the blower motor,
the blower resistor and the recirculation control
motor,
5. Remove the wire harness clip from the recirculation
control motor, and release the wire harness from the
clamp on the blower unit.
Remove the two mounting bolts, the mounting nut
and the blower unit.
6 x 1 . 0 m m
6 .
6 x 1 . O m m
9 . 8 N . m ( 1 . 0 k g f ' m ,
7.2 rbr.ftl
Install in the reverse order of removal. and make sure
there are no air leaks.
9 . 8 N . m ( 1 . 0 k g l ' m ,
Advertisement
Table of Contents
Troubleshooting
