Acura Integra 1998 Service Manual page 581

)
3 7 .
38.
Align the hole of the sub-shaft 1st gear with the
hole of the transmission housing. then insert a pin
to hold the sub-shaft while tightening the sub-shaft
locknut.
Install a new conical spring washers and new lock-
nuts on each shaft.
CAUTION: ln3tall the conical spring washers in the
direction shown.
Tighten the iocknuts to the specified torque.
NOTE:
a Do not use an impact wrench, always use a torque
wrench to tighten the locknut.
. Mainshaft and countershaft locknuts have left-
hand threads.
TOROUE:
MAINSHAFT 78 N.m {8.0 kgf.m, 58 lbf.ft}
COUNTERSHAFT 103 N.m {10.5 kgf.m, 75.9 lbtft}
SUB-SHAFT
93 N.m (9.5 ksf.m, 69 lbf.ftl
)
MAINSHAFT
LOCKNUT
Left hand threads.
PIN
8 m m p i n ,
commercially
40. Stake each locknut using a 3,5 mm punch as shown.
LOCKNUT
O . 7 - 1 . 2 m m
(0.03 -O.05 inl
Set the parking brake lever in the E position. then
verify that the parking brake pawl engages the park-
i n g g e a r .
lf the pawl does not engage tully, check the parking
brake pawl stop clearance as described on page
14- 1 58.
Tighten the lock bolt and bend the lock tab.
(cont'd)
4 1 .
t,\\--l--'-,4 l
';-.-='/
t _ ^
t'1ry
6 x 1 . 0 m m
PARKING BRAK€ PAWL
1 4 - 1 6 5