Table of Contents
Advertisement
Compressor
Replacement
l f t h e c o m p r e s s o r i s m a r g i n a l l y o p e r a b l e , r u n t h e
e n g i n e a t i d l e s p e e d , a n d l e t t h e a i r c o n d i t i o n e r
work a few minutes. Then shut the engine off.
Recover the refrigerant with a Recovery/Recycling/
Charging System \see page 22-22).
Remove the power steering pump (see section 17).
NOTE: Do not disconnect the hoses from the power
steering pump.
Disconnect the condenser fan connector.
Disconnect the compressor clutch connector, then
r e m o v e t h e c o m p r e s s o r c l u t c h c o n n e c t o r a n d t h e
clips from the condenser fan shroud
Remove the two mounting bolts and the condenser
f a n s h r o u d .
NOTE: Be careful not to damage the radiator fins
when removing the condenser fan shroud.
1.0 mm
N.m (1.0 kgt.m,
rbf.ftt
CONDENSER FAN SHROUD
COMPRESSOR
CLUTCH CONNECTOR
5.
Remove the bolts, then disconnect the suction line
and the discharge line from the compressor.
NOTE: Plug or cap the lines immediately aiter dis-
connecting to avoid moisture and dust contamina-
t i o n .
6 x 1 . 0 m m
9.8 N.m (1.0 kgf.m, 7.2 lbf.ft)
22-30
6.
Loosen the adjusl pulley bracket pivot bolt and the
a d j u s t i n g b o l t , t h e n r e m o v e t h e A / C c o m p r e s s o r
belt from the Dullev as shown.
ADJUSTING BOLT
A/C COMPRESSOR
BELT
Remove the four mounting bolts and the compres-
s o r .
NOTE: Be careful not to damage the radiator fins
when removing the compressor.
7 .
./.,
COMPRESSOR
Advertisement
Table of Contents
Troubleshooting
