Acura Integra 1998 Service Manual page 1002

I
I
J
F r o m p a g e 2 1 - 1 4
ls the mode control motor OK?
Y E S
N O
T o p a g e 2 1 - 1 6
View from wire side
BLU/WHT
GRNTYEL
(cont'dl
Check for continuily in the BLK
wire between the mode control
molor and body ground.
Check tor an oDen in the BLK wire
b€twe€n the mode control motor
and body ground. lf the wiro is
OK, check for poor ground at
G201 and G401.
Test the mode conlrol motor (see
page 21-281.
Remove the mode control motor
( s e e p a g e 2 1 - 2 8 ) .
Remove the heater control panel
l s e e p a g e 2 1 - 2 5 ) .
Check the mode control linkage
and doors for smooth movement,
Disconnect the heater control
panel 14P connector.
Ropair the modo contrcl
linkag€ or doors.
Do the mode control linkage
and doors move smoothly?
Check each wire for continuity be-
tween the mode control motor
and body ground.
. YEL/BLU wire
. YEL wire
. BLU/WHT wire
. GRN/YEL wire
' YEL/RED wire
ReDlace the mode conlrol molor.
Ropaii any short in the wiiolslbe-
tw6€n the mod€ control motor
and th€ heater control oan6l,
Check the same wires for voltaoe,
Ropair sho.t to power in the
BLK/YEL wir€ betweon the mod€
controlmotor and the hottor con-
trol panel. (This damagos thg
heater control oanel.)
ls there any voltage?
,.i:...
''{
'rt'',-
21-15