Hose Replacement - Acura Integra 1998 Service Manual

Hose Replacement
CAUTION:
a Betore reassembling, check thal all parts are free of
dust and othet foreign particles.
a Replace parts with new ones whenever specilied to
oo so.
a Do not spill brake tluid on the car; it may damage the
paint; if biake fluid does contact the paint, wash it
off immediatelv with water.
1 . R e p l a c e t h e b r a k e h o s e i f t h e h o s e i s t w i s t e d ,
c r a c k e d , o r i l i r l e a k s .
2. Disconnect the brake hose from the brake line using
a 10 mm llare nut wrench.
BRAKE LINE
FLARE NUT
WRENCH
(Commercially
available)
BRAKE HOSE
Remove and discard the brake hose clip from the
brake hose.
Remove the banjo bolt, and disconnect the brake
hose from the caliper.
5 .
BRAKE HOSE
MOUNTING BOLT
RS, LS, GS
{8 x 20 mm)
Install the brake hose on the knuckle and damper
first, then connect the brake hose to the caliDer with
t h e b a n j o b o l t a n d n e w s e a l i n g w a s h e r s .
BRAKE HOSE ERAKE HOSE MOUNTING
EOLT 18 x 16 mm)
2 2 N . m
{2.2 kgt.m, 16 tbf.ftl
GS-R and Type R
{8 x 25 mm)
22 N.m
(2,2 kgf.m, 16lbf.ftl
BANJO EOLT
t O r 1 . 0 m m
34 N.m
(3.5 kgf.m, 25 lbf.ft)
CAUTION: Do not twist the brake hose excessively.
Install a new brake hose clip on the brake hose.
Connect the brake line to the brake hose.
6 .
7 .
BRAKE HOSE MOUNTING
BOLT
9.8 N.m {'1.0 kst.m, 7 tbt.fi}
BRAKE LINE
15 N.m (1.5 kgt m, 11 lbf.ftl
BRA(E HOSE CLIP
Replace.
After installing the brake hose, bleed the brake sys-
tem (see page 19-7).
Perlorm the following checks.
a Check the brake hose and line joint for leaks, and
tighten it necessary.
a Check the brake hoses for interference or
r w r s l r n g .
.:2-.
- - l
L
19-21