- Hub Bearing Unit
Removal
1. Loosen the wheel nuts slightly.
2.
Raise the rear of vehicle, and support it with safety
stands in the proper locations (see section 1).
3.
Remove the wheel nuts and rear wheel.
NOTE: Take care not to damage the hub unit
on disassembly.
4.
Pull the parking brake lever up.
5.
Remove the hub cap.
6 . R a i s e t h e l o c k i n g t a b o n t h e s p i n d l e n u t , t h e n
remove the nut.
7.
Remove the 6 mm brake disc retaining screws.
R e p l a c e .
8 .
9 .
Release the parking brake lever.
Remove the 6 mm flange bolts and caliper shield.
C A L I P E R S H I E L D
C h e c k f o r b e n d i n g o r d a m a g e .
6 mm FLANGE BOLTS
(cont'd)
1 8 - 2 9