Table of Contents
Advertisement
Transmission
20.
2 1 .
Reassembly (cont'dl
I n s t a l l t h e d o w e l p i n s .
I n s t a l l t h e t r a n s m i s s i o n h o u s i n g b y a l i g n i n g t h e
groove in the housing with finger on the stop ring.
GROOVE
Lower the transmission housing with the snap ring
p l i e r s , a n d s e t t h e s n a p r i n g i n t h e g r o o v e o f t h e
countershaft bearing.
TRANSMISSION
HOUSING
13-44
23. Check that the snap ring is securely seated in the
groove of the countershaft bearing.
Dimension @ as installed: 4.6 - 8.3 mm
(0.181 - 0.327 inl
24. Install the transmission hanger A and back-up light
switch clarnp, then tighten the transmission hous-
i n g a t t a c h i n g b o l t s i n t h e n u m b e r e d s e q u e n c e
shown below.
ATTACHING BOLTS
I x 1.25 mm
27 N.m (2.8 kgf.m, 20 lbf.ft)
BACK.UP LIGHT
SWITCH CLAMP
\'
Advertisement
Table of Contents
Troubleshooting
