Table of Contents
Advertisement
Installthe airbag assembly with new Torx bolts, and
installthe covers.
cRursE
CONTROL
SET/RESUME
swtTcH covER
Hold the pawl side connector half. and press on the
back of the sleeve-side connector halt in the direction
shown. As the two connector halves are pressed
together, the sleeve is pushed back by the pawl.
NOTE: Do not touch the sleeve.
7 .
When the connector halves are completely connected.
the pawl is released. and the spring loaded sleeve
locks the connector.
SPRING.LOADED
SLEEVE
Attach the connector in the holder, then install the
access panel on the stee.ing wheel lower cover.
Connect the positive cable first. then the negative
cable to the battery.
After installing the airbag assembly, confirm proper
system operation:
. Turn the ignition switch ON (ll); the instrument
p a n e l S R S i n d i c a t o r l i g h t s h o u l d c o m e o n f o r
about six seconds and then go off.
. Confirm operation of horn buttons.
. Confirm operation of cruise control sevresume
switches.
1 0 .
1 7 - 2 7
Advertisement
Table of Contents
Troubleshooting
