Acura Integra 1998 Service Manual page 412

I
Transmission Assembly
1 .
2 .
Install the dowel pins on the clutch housing.
Apply grease to the parts as shown, then install the
release fork and release bearing.
N O T E : U s e o n l y S u p e r H i g h T e m p U r e a G r e a s e
(P/N 08798 - 9002).
3.
Install the release fork boot.
lnstallation
22 tbl.lll
RELEASE FORK BOLT
29 N.m {3.0 kgl.m,
{P/N 08798 - 9002t
RELEASE
BEAFING
RELEASE
FORK
lPlN 08798 - 90021
P l a c e t h e t r a n s m i s s i o n o n t h e t r a n s m i s s i o n j a c k ,
and raise it to the engine level.
Install the transmission mounting bolts and the rear
mount bracket bolts.
SELF.LOCKING BOLT
12 x 1.25 mm
64 N.m {6.5 kgf.m, {7 lbtftl
R e p l a c e .
1 4 x 1 . 5 m m
RELEASE
FORK
BOOT
\i'l
- r )
i -
.+.i
1 3 - 46
6.
Raise the transmission, then install the transmission
m o u n r ,
N O T E : T o r q u e t h e m o u n t i n g b o l t a n d n u t s i n t h e
sequence shown.
CAUTION: Check that the bushings are not twisted
or offset.
!) tz x t.zs mm
64 N.m {6.5 kgt.m,
47 tbl.ftl
7. Install the three upper transmission mounting
and the lower staner motor mountinq bolt.
bolts
10 x 1.25 mm
44 N.m (4.5 kgt m.
33 tblftl
(a 12 x 1.25 mm
74 N.m {7.5 kgf m,
54 tbf.ft)
' 1 2 x 1 . 2 5 m n
64 N.m {6.5 kst.m,47 lbf,ft)