Table of Contents
Advertisement
Inspection
'1.
Drain the fluid from the pump.
Hold the steering pump in I vise with soft jaws,
hold the pulley with the special tool, and remove
the pulley nut and pulley.
CAUTION: Be careful not to d8m8go lh€ pump
hoBing with tho iEws ol the vi3e.
UNIVERSAL HOLDER
07725 - lxt3(xxlo
Dr l I Ev Nr rr
Loosen the flow control valve cao with a hex wrench
ano remove |l.
4.
Remove the O-ring, {low control valve and spring,
5.
Remove the inlet joint and O-ring.
6.
Remove the pump cover and pump cover se8l.
7.
Remove the outer side plate, pump cam ring, pump
rotor, pump vanes, side plate and o-rings.
8.
Bemove the circlip, then remove the pump drive
shaft by tapping the shaft end with th€ plastic h8m-
mer.
9.
Remove the pump seal spacer and pump seal.
I
Flow Control Valv€:
1. Check the flow control valve for wear. burrs, and
other damage to the edges of the grooves in the
valve.
FLOW
CONTROL VALVE
Inspect the bore the flow control valve for scrstches
or wear,
Slip the valve back in the pump, and check that it
moves in and out smoothly.
lf OK, go on step 4; if not, replace the pump as an
assembly. The flow control valve is not available
separately.
Attach a hose to the end of the valve as shown.
FLOW CONTROL VALVE
(cont'd)
d a m a g e t o e d g e s .
17-37
Advertisement
Table of Contents
Troubleshooting
