Table of Contents
Advertisement
Transmission Housing Bearings
Mainshaft/Countershaft Bearing Replacement
1, To remove the mainshaft and countershaft bearings
from the transmission housing, expand each snap
ring with snap ring pliers, then push the bearing out
using the special tools and a press as shown.
NOTE: Do not remove the snap rings unless it's
necessary to clean the grooves in the housing.
DRIVER
07749 -OOrOO00
ATTACHMENT,
6 2 x 6 8 m m
I
07746-OO1
--_-e;
\ )
Mainshaft Romoval use:
ATTACHMENT,
07746-0010600
Countarshaft Removal use:
ATTACHMENT,
6 2 x 6 8 m m
07746 0010500
TFAr{SMTSSION
T|oUSING
,,',zs>.\
/qnH
\1b22
PRESS
MAINSHAFT BEARING
2 . Expand each snap ring with snap ring pliers, insert
the new bearing part-way into the housing using the
soecialtools and a oress as shown. Install the bear
ing with the groove facing outside the housing.
NOTE: Coat all parts with ATF.
Release the pliers, then push the bearing down into
the housing until the ring snaps in place around it.
DRIVER
07749-0010000
Mainshafl Installation u86:
ATTACHM€NT.
7 2 x 7 5 m m
07746 -0010600
Countershaft Installation use:
ATTACHMENT,
6 2 x 6 8 m m
07746-0010500
GROOVE
4. After installing the bearing verify the following:
a The snap ring is seated in the bearing and hous-
Ing grooves.
a The ring end gap is correct.
SNAP RING
END GAP: O-7 mm
L
1 4 - 1 5 6
Advertisement
Table of Contents
Troubleshooting
