Knuckle Removal - Acura Integra 1998 Service Manual

1 .
Knuckle Removal
Loosen the wheel nuts slightly.
Raise the front of vehicle. and support it with safety
stands in the proper locations {see section l ).
B€move the wheel nuts and front wheel.
SPINDLE NUT
22 x 1.5 mm
Replace.
R a i s e t h e l o c k i n g t a b o n t h e
remove the nut.
s p i n d l e n u t . t h e n
Remove the brake hose mounting bolts.
Remove the caliper bracket mounting bolts, and
hang the caliper to one side.
CAUTION: To pravant accidental damage to thg
caliper or braks hoso, use a shqrt piece of wirs to
hsng the c8liper flom the undercarriage.
CALIPER BRACKET MOUNTING BOLTS
12 x 1.25 mm
7, Remove the 6 mm brake disc retaining screws.
BRAKE DISC
Check for wear and rust.
Inspection, section j9.
8. Screw the two I x L25 mm bolts into the disc to
push it awav from the hub.
NOTE: Turn each bolt two turns at a time to pre-
vent cocking the disc excessively.
Remove the brake disc from the knuckle.
Check the front hub for damage or cracks.
R e m o v e t h e w h e e l s e n s o r w i r e b r a c k e t , t h e n
remove the wheel sensor lrom the knuckle (for vehi-
cles with ABS).
NOTE: Do not disconnect the wheel sensor connec-
ror.
4.
6.
1 0 .
1 1 .
WHEEL SENSOF
WIRE BRACKET
FRONT WHEEL
8 x 1.25 mm BOLTS
WHEEL SENSOR
(cont'd)