Abs Control Unit - Acura Integra 1998 Service Manual

ABS Control Unit
RemovaUlnstallation
1. Remove the right quarter trim panel.
2.
Disconnect the ABS control unit connectors.
3. Remove the ABS control unit.
Pulsers/Wheel Sensors
Inspection
/t
l \
I
Check the front and rear pulser for chipped or dam-
aged teeth.
Measure the air gap between tho wheel sensor and
pulser sllthe way around while rotating the pulser.
Standard: 0.4 - 1.0 mm (0.02 - 0.04 in)
N O T E : l f t h e g a p e x c e e d s 1 . 0 m m ( 0 . 0 4 i n ) , t h e
p r o b a b i l i t y i s a d i s t o r t e d s u s p e n s i o n a r m w h i c h
should be reDlaced.
Front/R..1
L-TJ
. t -
t =
l-
E
t-
E_
Install the ABS control unit in the reverse order of
removal.
Start the engine, and check that the ABS indicator
goes off.
Test-drive the vehicle, and check that the ABS indi-
cator does not come on.
19-62