Table of Contents
Advertisement
Mainshaft
!
Clgarance Measurement
NOTE: Lubricate all parts with ATF during assembly,
1 . Remove the mainshaft bearing from the transmission
h o u s i n g { s e e p a g e 1 4 - 1 5 6 ) .
2. Assemble the pans below on the mainshaft.
NOTE: Do not assemble the O-rings during in-
spection.
CONICAL
WASHER
Inspection
SNAP RING
lST CLUTCH ASSEMBLY
THRUST WASHER
lST GEAR COLLAR
TRANSMISSION
HOUSING BEARING
THRUST WASHER
TH GEAR COLLAR
2ND/4TH CLUTCI{
ASSEMALY
THRUST WASHER
36.5 x 55 mm
Selective part
THRUST NEEDLE
BEARING
zND GEAR
BEARING
THRUST N€EDLE
BEARING
M A I N S H A F T
14-134
3 . T o r q u e t h e m a i n s h a t t l o c k n u t t o 2 9 N . m ( 3 . O
kgf.m, 22 lbt.tt).
NOTE: Mainshaft locknut has left-hand threads.
29 N.m (3.0 ksl'm,22 lbf'ftl
Hold 2nd gear against the 2nd clutch, then meas-
ure the clearance between 2nd gear and 3rd gear
with a feeler gauge.
NOTE: Take measurements in at least three places,
and use the average as the actual clearance.
S T A N D A R D : 0 . 0 5 - 0 . 1 3 m m 1 0 . 0 0 2 - 0 . 0 0 5 i n )
THRUST WASHER,
36.5 x 55 mm
3RD GEAR
2ND GEAR
Advertisement
Table of Contents
Troubleshooting
