Acura Integra 1998 Service Manual page 505

Shift Control Solenoid Valve A/B Assembly
Test
NOTE: Shift control solenoid valves A and B must be
removed/replaced as an assembly.
l .
D i s c o n n e c t 3 P c o n n e c t o r f r o m t h e s h i f t c o n t r o l
solenoid valve A,/B assembly.
2.
Measure the resistance between the No. 1 terminal
(solenoid valve A) of the shift control solenoid valve
connector and body ground, and between the No. 3
terminal (solenoid valve B) and body ground.
STANDARD: 12 - 25 o
Replace the shift control solenoid valve assembly if
the resistance is out of sDecification.
lf the resistance is within the standard, connect the
No. 1 terminal of the shift control solenoid valve con-
nector to the battery positive terminal. A clicking
sound should be heard. Connect the No. 3 terminal to
the battery positive terminal. A clicking sound should
be heard. Replace the shift control solenoid valve
assembly if no clicking sound is heard.
J
1.0 mm
N.m {1.2 kgf m, 8.7 lbf'ft)
\
\ ^ ,, ..,'
UYM
6 x
't2
a
SOLENOID
v.
SHIFT CONTROL
SOLENOID VALV€ A/B
ASSEMBLY
Replacement
Remove the mounting bolts and shift control sole-
noid valve ly'B assemblv.
NOTE: Be sure to remove or replace the shift con-
trol solenoid valves A and B as an assemblY.
Check the shift control solenoid valve fluid pas-
sages for dust or dirt, and replsce as an assembly, if
necessarv.
BRACKET
Clean the mounting surface
and tluid passages.
VALVE A/B ASSEMBLY
FILTER/GASKET
Replace.
Clean the mounting surfsce and fluid passages of
t h e s h i f t c o n t r o l s o l e n o i d v a l v e a s s e m b l y , a n d
install a new shift control solenoid valve Ay'B with a
new filter/gasket.
Check the connector for rust, dirt or oil, and recon-
nect at securely.
1 4 - 8 8