Power Steering
Gearbox
Removal
NOTE: Using solvent and a brush, wash any oil and dirt
off the valve body unit, its lines, and the end if the gear-
box. Blow dry with compressed air.
l.
Drain the power steering fluid as described on page
11-21.
2.
Raise the front of vehicle, and support on safety
stands in the proper locations (see section 1).
3.
Remove the front wheels.
4. When the vehicle is equipped with the SBS airbag
system, remove the steering wheel (see page 17-
24t.
5.
Remove the steering
6.
Remove the steering joint lower bolt, and move the
ioint toward the column.
STEERING JOINT
LOWER SOI-T
(cont'd)
1 9 . I n s t a l l t h e p u l l e y a s s h o w n b e l o w , t h e n l o o s e l y
install the pulley nut. Hold the steering pump in a
vise with soft jaws.
CAUTION: Be carelul not to damlge tho pump
hou3ino with ths ilws of th6 vies.
Hold the pulley with the special tool, and tighten the
pu ey nut.
ioint
Va
20.
PULI.IY NUT
6,1 N.m {6.5 kgt m,
47 lbf,ftl
'(
Check that the pump turns smoothly by turning the
pulley by hand.
.-l
2 1 .
PULLEY
UNIVERSAL HOLDER
CLIP
17-41