Table of Contents
Advertisement
Rear Window
Removal
5 .
6 .
W i t h a h e l p e r o n t h e o u t s i d e , p u l l t h e p i a n o w i r e
back and forth in a sawing motion, and carefully cut
through the adhesive along the too and the sides of
the rear window.
CAUTION: Hold the piano wile as close to the rear
window as possible to prevent damage to the body
and molding.
PROTECTIVE TAPE
Cut the adhesive with a knile at the bottom ot the
N O T E | D o n o t u s e p r a n o w r r e I n l h r s a r e a .
C a r e f u l l y r e m o v e t h e r e a r w i n d o w .
NOTEr Replace the fasteners with
new
ones
w h e n e v e r t h e r e a r w i n d o w h a s b e e n r e m o v e d .
GLASS
PROTECTIVE TAPE
Hatchback
C A U T I O N :
a Use covers to avoid damaging the interior.
a Wear gloves to remove and install the glass.
a Do not damage the defroster glid lines.
a Take care not scratch the rear window moldino.
1 . T o r e m o v e t h e r e a r w i n d o w , t i r s t r e m o v e t h e :
. R e a r s h e l f ( s e e p a g e 2 0 9 1 )
. Hatch side trim and hatch trim panel (see page
20-14A1
a H i g h m o u n t b r a k e l i g h t ( s e e s e c t i o n 2 3 )
a Rear window wiper arm and rear window wiper
motor (see section 23)
2 .
R e m o v e t h e r e a r w i n d o w t r i m , a n d d i s c o n n e c t t h e
c o n n e c t o r s ,
Apply protective tape to the inner and outer edges
o f t h e h a t c h .
Using an awl, make a hole through the adhesive from
the inside, at the top of the hatch. Push piano wire
through the hole, and wrap each end around a piece
of wood.
3 .
CONNECTOR
MOLDING
Advertisement
Table of Contents
Troubleshooting
