J
I
J
I
)
1 . To remove the sub-shatt bearing from the transmis-
sion housing, expand the snap ring with snap ring
plie.s, then push the bearing out using the special
tools and a Dress as shown.
NOTE: Do not remove the snap ring unless it's
necessary to clean the groove in the housing.
PRESS
ATTACHMENT-
6 2 r 6 8 m m
07746-OOr 0500
SNAP RING
ATTACHMENT-
6 2 x 6 8 m m
07746-0010500
Expand the snap ring with snap ring pliers, insert the
new bearing pan-way into the housing using the spe-
cial tools and a press as shown. Install the bearing
with the groove facing outside the housing.
NOTE: Coat all pans with ATF.
Release the plie.s, then push the bearing down into
the housing until the ring snaps in place around it,
using the special tools as shown.
DRIVER
07749-OOlOO00
ATTACHMENT,
6 2 x 6 8 m m
07746 -0010500
4 .
GROOVE
After installing the bearing verify the following:
a The snap ring is seated in the bearing and hous-
ing grooves.
a The snap ring operates properlY
a The ring end gap is correct.
SNAP RING
END GAP: 0-7 mm
t
14-157