Acura Integra 1998 Service Manual page 613

Tapered Roller Bearing Preload Adjustment
NOTE: lf any of the items listed below were replaced,
the tapered roller bearing preload must be adjusted.
a Transmission housing
a Clutch housing
a Ditferential carrier
a Tapered roller bearing and bearing outer race
a Thrust shim
1 . Remove the bearing outer race, the thrust shim, and
the 79.5 mm shim from the transmission housing
( s e e p a g e 1 5 - 1 4 ) .
CAUTION: Do not reuse the thrust shim if the bea.-
ing outer race was driven out-
2. First try the same size 79,5 mm shim that was
removeo.
CAUTION: Do not use more than two shims,
79.5 mm SHIM
HOUSING
3 . Install the thrust shim and 79.5 mm shim, then drive
the bearing outer race in the transmission housing
{ s e e p a g e 1 5 - ' 1 4 ) .
N O T E I
a Install the bearing outer race squarely.
a Check that there is no clearance between the
bearing outer race, thrust shim and transmission
housing.
With the mainshatt and countershaft removed, in-
stall the dillerential assembly, and torque the clutch
housing and transmission housing.
8 x 1 . 2 5 m m
27 N.m (2.8 kgf.m. 2O lbf.ft)
NOTE: lt is not necessary to use sealing agent be-
tween the housings.
Rotate the ditferential assembly in both directions
to seat the tapered roller bearings.
Measure the tapered roller bearing preload ot the
dilferential assembly with the special tool and a
t o r q u e w r e n c h .
NOTE: Measure the tapered roller bearing preload
in both directions.
S T A N D A R D : 2 . 1 1 - 3 . O 4 N ' m
( 2 1 . 5 - 3 1 . O k g f ' c m ,
1 8 . 7 - 2 6 . 9 l b t . i n l
PRELOAD INSPECTION TOOL
07HAJ-PK40201
( c o n t ' d )
6 .
5 -1