Table of Contents
Advertisement
t
{
)
)
Based on signals received from the vehicle speed sensor (VSS). the microcomputer in the maintenance reminder unit,
which is located behind the dashboard lower cover, computes the distances traveled. When you turn the ignition switch
ON (ll), the reminder light in the gauge assembly will come on for two seconds (bulb check tunction). At 9,650 1 160
km {6,000 1 1O0 miles} intervals, the reminder light will glow for two seconds and then blink ten seconds after you
turn the ignition switch ON (ll). This will repeat every rime you turn the ignition switch ON {ll) until rhe car reaches
1 2 , O 7 O ! 1 6 0 k m ( 7 , 5 0 0 t 1 0 0 m i l e s ) .
Beyond the 12.o1O ! 160 km (7,5OO t
IOO mile) interval, the light will continue to glow after the bulb check until
you turn the ignition switch otf or reset the unit.
To reset the unit, the car must be parked and the ignition switch must be ON (ll). Press the reset button on the unit
for more than three seconds, and the reminder light will go off.
NOTE:
. Turn the ignition switch OFF before you remove the 5P connector from the maintenance reminder unit, otherwise vou
wiil cancel all data in the memory.
a The data will remain in the memory even when the ignition switch is turned off, or if the unit is disconnected. When
the ignition switch is turned ON (lll, and the car is driven, additional data will be stored.
{
23-137
Advertisement
Table of Contents
Troubleshooting
